User Tools
langstroth_hive_components
Differences
This shows you the differences between two versions of the page.
|
langstroth_hive_components [2020/09/29 03:57] tallmtt [Materials] |
langstroth_hive_components [2021/07/28 21:08] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Langstroth Hive Components ====== | ||
| - | |||
| - | A Langstroth Hive is composed of: | ||
| - | - Bottom board/floor | ||
| - | - Deep Hive Body/Super | ||
| - | - 8-10 Frames with or without Foundation per Super | ||
| - | - Optionally: | ||
| - | - Queen excluder | ||
| - | - Additional Supers (Deep or Mediums) | ||
| - | - Inner Cover | ||
| - | - Outer Cover/Roof | ||
| - | |||
| - | ===== Plans to build a 10-Frame Super (Hive Body) ===== | ||
| - | |||
| - | === Tools === | ||
| - | |||
| - | * Table saw or Skill saw | ||
| - | * Drill | ||
| - | * Paint brush | ||
| - | |||
| - | ==== Materials ==== | ||
| - | |||
| - | * For a Deep Super: 2" x 10" x 8' Pine board (For a Medium Super: 2" x 8" x 8' Pine board) | ||
| - | * Wood glue | ||
| - | * Wood screws | ||
| - | * Paint | ||
| - | |||
| - | ==== Instructions ==== | ||
| - | |||
| - | - Cut the 8-foot board into: | ||
| - | * 2 pieces that are 19 7/8" long | ||
| - | * 2 pieces that are 14 3/4" long | ||
| - | - Cut a rabbet on the length of the 14 3/4" boards 3/ | ||
| - | - Drill pilot holes for wood screws through the 19 7/8" boards into the ends of the 14 3/4" boards | ||
| - | - Glue and screw the hive body together | ||
| - | - Paint only the outside of the hive body | ||
| - | |||
| - | |||
| - | |||
| - | |||
| - | |||
| - | |||
| - | |||
langstroth_hive_components.txt ยท Last modified: 2021/07/28 21:08 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
